Florance Amplifiers

Florance Amplifiers are co-effort between Peter Florance and Todd Vukmanic started in 2003.
In the pursuit of FineVintage tone in Modern amps we have come up with this line of Fine Amplifiers.

"HALF-PLEX"
The " HALFPLEX" is a 2 el84 amp with tones of an amplifier twice its power. The amp can dial in tight AC30 tones and then with a turn of the controls sound like an early Marshall 50 watt... along with the juicey Vintage tones you can choose between a tube recitfier and a solid state recifier .
It also alows you to choose between a coil choke and a resistor...
Every detail of Florance amps are built to inhance tone.
Our original "Temper" control which can dial in how tight or fierce you want the front end to react.
Or our "Pressure" control on the rear of the amp to
dial in a compressed or tones that are full and open.

Custom fabricated NOS Paxolin circuit boards
Micalex tube sockets
NOS paper-in-oil capacitors and Metalized polyester (Mallory M150)
Teflon hook-up wire
Cliff input jacks
Carling switches
5 watt Ceramic power resistors
1/2 watt carbon composition resistors
18 AWG and 20 AWG Belden silver-plated copper
Custom fabricated aluminum chassis
Custom specified/fabricated transformers (Heyboer)
Custom fabricated amplifier/speaker cabinets
Custom fabricated flamed-maple chassis end blocks
Tube Rectifier / Solid State Recifier
Coil Choke/ Resistor Choke

Every detail of Florance amps are built to inhance tone.
Our original "Temper" control which can dial in how tight or fierce you want the front end to react.
Or our "Pressure" control on the rear of the amp to dial in a compressed tone or tones that are full and open.